We discuss an optical system that encodes an input signal to a polarization state, using a spatial light modulator (SLM). Using two SLMs the optical system multiplexes two 2D signals in the polarization domain, and we ...
Digital speckle photography can be used in the analysis of surface motion in combination with an optical linear canonical transform (LCT). Previously [D. P. Kelly et al. Appl. Opt. 44, 2720 (2005)] it has been shown that ...
Nonlocal Polymerisation Driven Diffusion model describes grating formation in
photopolymer materials and gives valuable insight into the processes taking place during formation. For weak exposures, NPDD reduces to a ...
In speckle-based metrology systems, a finite range of possible motion or deformation can be measured. When coherent imaging systems with a single limiting aperture are used in speckle metrology, the observed decorrelation
effects ...
Bridge Weigh-In-Motion (B-WIM) is a process by which the axle and gross vehicle weights of vehicles travelling at highway speeds can be determined from instrumented bridges. The traditional method of attaching strain ...
The paper considers the influence of the surface profile on the dynamic amplification of a simply supported bridge when subject to a quarter car vehicle model. The effect of the profile irregularities on the bridge dynamic ...
The concept of a road roughness index for bridge dynamics is developed. The International Roughness Index (IRI) is shown to be very poorly correlated with bridge dynamic amplification as it takes no account of the location ...
Sky luminance is an essential component in assessing the appearance and performance of
internal spaces which are highly sensitive to the often dynamic luminance of the visible sector
of the sky. Therefore, whole sky ...
An elegant, generic solution is presented to the problem of point-to-point control by a single actuator of a remote load through an intermediate flexible system, modelled by a system of lumped masses and springs. It is ...
The response of a bridge to a pre-weighed truck can be
measured on site. This paper describes a mathematical
method for converting the measured response of a load
effect into an influence line for that effect. One ...