RSS
- You are here:
- Research Repository UCD
- >
- Search
JavaScript is disabled for your browser. Some features of this site may not work without it.
Search
Search Results
-
(dendro.dk, 2008-03)Dendrochronological dating and timber provenance of a ship found at Juvre Sand, Denmark. Result after c. 1770
-
(American Society of Civil Engineers, 2009-06)This paper presents the results of a series of field experiments performed to study the development of shaft resistance on Continuous Flight Auger piles installed in sand. The test piles were instrumented in order to ...
-
(Institution of Civil Engineers/Thomas Telford Publishing, 2009-10)This paper presents the results from an experimental programme that studied the factors affecting the bearing resistance of shallow footings in sand. In particular, the tests considered the effects of the footing width and ...
-
(Elsevier, 2012-11)Significant research effort has led to improvements in our ability to estimate the ultimate bearing resistance of footings in sand. These techniques often estimate the footing resistance at relatively large displacements, ...
-
(NRC Research Press, 2007-05)The Multichannel Analysis of Surface Waves (MASW) technique, used to determine shear wave velocity (Vs) and hence small strain stiffness (Gmax), has recently generated considerable interest in the geophysics community. ...
-
(University College Dublin. School of Archaeology, 2011-09)At the spring tides, during the summer of 2011, a team from the School of Archaeology, University College Dublin, made several research trips to a complex of medieval fishweirs at a location close to Boarland Rock on the ...
-
(Elsevier, 2011-06)The paper considers two techniques to model the Cone Penetration Test (CPT) end resistance, qc in a dense sand deposit using commercial finite element programmes. In the first approach, Plaxis was used to perform spherical ...
-
(John Wiley and Sons, 2009-11)Sandstone provenance studies can help constrain palaeogeographic reconstructions and ancient drainage system scales and pathways. However, these insights can be obscured by difficulties in geochemically distinguishing or ...
-
(Institution of Civil Engineers, 2011-08-01)The paper considers the current state of the art for estimating the pull-out capacity of driven open-ended piles used to support wind turbine foundations founded on sand. The latest edition of the American Petroleum Institute ...
-
(ASTM International, 2010-01)This paper describes the development of a model instrumented open-ended (pipe) pile. The importance of model geometry and separating the shaft, annular and plug load, and horizontal effective stresses is discussed. A ...